Psdrv3 install failed

Details required :. Cancel Submit. DaveM Independent Advisor. Hi Anthony I am Dave, I will help you with this. How satisfied are you with this reply?

Thanks for your feedback, it helps us improve the site. In reply to DaveM's post on November 24, It's fixed my problem.

I hope it will be helpfull for you too. Without the power adapter i would only get the Microsoft Kinect Device driver I get all 4 working properly in the Device Manager. Q: Is there any diagnostic tool for kinect? This error message is not helping. Removing this from the register and removing that file, that solves my problems.

Dont know its source but some uninstaller did not clean up after itself. Just dont tell me i need to update the drivers for the graphicboard, newer ati drivers dont support Wacom 12wx Clintiq device newer ati drivers will make both screens go black :. I have run kinect demo both with it connected and disconnected so it is probably not the problem. Hi, I tried what you mentioned and I did find some references to that driver in my registry. Although, even after removing those references and deleting the file from the disk, I still cannot run the ShapeGame app or the SkeletalViewer where I still get the same errors I had before to connect the Kinect and try again.

I have an idea. Perhaps you have some software that installed Prime Sense. In that case try this:. I have the same problem, same error 0x There are no Prime Sense or other 3rd party drivers installed. All 4 devices where shown in device manager. Green LED on Kinect is blinking. Power supply is ok. I also tried jimstein's suggestion but did not work either although I found some other entries in the registry to PrimeSense.

My problem is that other usb devices interfered with the kinect. As soon as I disconnected the wire between my flatscreen and my computer the screen is also a usb hub , it worked.

In my case the issue also was in power supply. Somehow my power adaptor wasn't working correctly. Until I figured it out I could enjoy only exceptions.

The content you requested has been removed. Ask a question. Quick access. Reply to author. Report message as abuse. Show original message. Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message. My machine runs Windows 7 64 bit. I installed OpenNI 1. The demos all fail and there are no new camera devices shown in Device Manager.

When I try to run NiViewer, the message is: One or more of the following nodes could not be enumerated: blank line follows Perhaps I need a 64 bit version of the driver? Where can I get a prebuilt 64 bit driver? Do I need anything else to run the demos? Thanks, Mike. Rui Marinho. I never was prompted for the key, because Step 1 seemed to fail so I stopped. Today I uninstalled OpenNI and restarted the sequence.

Here are my results:. The installation program reported "Setup was completed successfully". Installed SensorKinect-Win The directory tree is:. Hello Mike, There should be more directories under the "Sensor" directory I think you are installing the wrong file by mistake.

I uninstalled the device from device manager. However, this did not seem to be sufficient to remove Sensor- Win My currently installed programs are shown. Should I remove one or more of them? Do I need to reboot?